Operation Manual
Table Of Contents
- 1. Safety instructions
- 2. Application
- 3. Features
- 4. Technical data
- 5. Dimensional drawing
- 6. Determination of the installation point
- 7. Inlet and outlet sections
- 8. Sensor installation
- 9. Sensor signal outputs
- 10. Sensor display (option)
- 11. Service App S4C-FS
- 12. Calibration
- 13. Maintenance
- 14. Disposal or waste
- 15. Warranty
- 16. Appendix A - Analogue output
- 17. Appendix B - Modbus communication example
- 18. Appendix C - LRC and CRC calculation
8. Sensor installation
Maximum angle deviation of a proper installation:
Removal of the sensor
1. Hold the flow sensor.
2. Release the clamp sleeve at the connection thread.
3. Pull out the shaft slowly until the value “10” can be read at the
scale.
4. Close the ball valve.
5. Release the connection thread and unscrew the flow sensor.
S401 19