Operation Manual
Table Of Contents
- 1. Safety instructions
- 2. Application
- 3. Features
- 4. Technical data
- 5. Dimensional drawing
- 6. Determination of the installation point
- 7. Inlet and outlet sections
- 8. Sensor installation
- 9. Sensor signal outputs
- 10. Sensor display (option)
- 11. Service App S4C-FS
- 12. Calibration
- 13. Maintenance
- 14. Disposal or waste
- 15. Warranty
- 16. Appendix A - Analogue output
- 17. Appendix B - Modbus communication example
- 18. Appendix C - LRC and CRC calculation
7. Inlet and outlet sections
7. Inlet and outlet sections
The thermal measuring principle may be sensible to inlet and outlet
conditions. For this we recommend the following minimum straight inlet
and outlet sections to ensure an accurate measurement. Sensor should
be always installed upstream from obstacles like valves, filter,
reductions etc. In common the sensor should be installed as far as
possible away from any disturbances.
Note: If there is any combination of the below, the longest straight inlet
section must be maintained.
• Expansion • Reduction
• 90° Bend • 2 x 90 ° Bend
S401 13