Datasheet

FACET
TM
— Product Data Sheet
High Strength Roof Equipment Mounng System
Ideally suited for aachment of solar racking, electrical and mechanical equipment
Installaon: Facet typically installs for solar PV in
6 - 8 minutes with the following steps:
1. Clean roof surface of dirt and debris
2. Place Facet loosely onto the roof, where it will
provide a stable base for racking installaon
3. Remove double sided sealing washer protecve tape
and place pre-cut roof membrane cover over Facet
4. Aach racking (and even modules), Facets will ‘nd’
their natural locaon
5. Install fasteners, number and type specied by your
structural engineer
6. Facet allows installaon up to 16 fasteners, allowing
maximum exibility and strength opons
7. Heat-weld roof membrane cover to roof
*Facets are shipped without roof membrane
Simply match your exisng roof product to prepare
the cover
U.S. Patent Number 9479110
History:
Facet has been deployed at over 10MW of solar installaons in the US, Europe and Pacic Islands. A 6MW
New Jersey installaon weathered both Irene and Sandy with ZERO failures or issues. Facet is suitable even
in the Pacic Islands, with 195 mph design specicaon.
Test Result
Upli Resistance > 5,000 lbs.
Shear Resistance > 4,000 lbs.
Todd Lindstrom
916-240-2808
[e-mail]
Eric Haer
916-286-2060
eha[e-mail]
Jack Paon
916-206-2920
jpa[e-mail]