Quick Start Guide
4a Insert the original driver CD-ROM into your CD or DVD drive.
4b Select Other > Install SoundFonts to copy SF2 SoundFonts™ to your
hard disk. The SoundFonts are saved in the directory /usr/share/
sfbank/creative/.
5 If you have congured more than one sound card in your system you can adjust
the order of your sound cards. To set a sound card as primary device, select
the sound card in the Sound Conguration and click Other > Set as the Primary
Card. The sound device with index 0 is the default device and thus used by
the system and the applications.
6 Per default, openSUSE uses the PulseAudio sound system. It is an abstraction
layer that helps to mix multiple audio streams, bypassing any restrictions the
hardware may have. To enable or disable the PulseAudio sound system, click
Other > PulseAudio Conguration. If enabled, PulseAudio daemon is used to
play sounds. Disable PulseAudio Support in case you want to use something
else system-wide.
The volume and conguration of all sound cards are saved when you click OK and
leave the YaST sound module. The mixer settings are saved to the le /etc/asound
.state. The ALSA conguration data is appended to the end of the le /etc/modprobe
.d/sound and written to /etc/sysconfig/sound.
13.3 Setting Up a Scanner
You can congure a USB or SCSI scanner with YaST. The sane-backends package
contains hardware drivers and other essentials needed to use a scanner. Scanners
connected to a parallel port cannot be congured with YaST. If you own a HP All-In-
One device, see Section 13.3.1, “Conguring an HP All-In-One Device” (page 161),
instructions on how to congure a network scanner are available at Section 13.3.3,
“Scanning over the Network” (page 161).
Procedure 13.3: Conguring a USB or SCSI Scanner
1 Connect your USB or SCSI scanner to your computer and turn it on.
2 Start YaST and select Hardware > Scanner. YaST builds the scanner database
and tries to detect your scanner model automatically.
If a USB or SCSI scanner is not properly detected, try Other > Restart Detection.
3 To activate the scanner select it from the list of detected scanners and click
Edit.
4 Choose your model form the list and click Next and Finish.
5 Use Other > Test to make sure you have chosen the correct driver.
160 Start-Up