Operation Manual

3
Add the prepared PVs to the VG by selecting the device and clicking on Add.
Selecting several devices is possible by holding Ctrl while selecting the devices.
4
Select Finish to make the VG available to further conguration steps.
Figure 2.3
Creating a Volume Group
If you have multiple volume groups dened and want to add or remove PVs, select the
volume group in the Volume Management list. Then change to the Overview tab and
select Resize. In the following window, you can add or remove PVs to the selected
volume group.
Conguring Logical Volumes
After the volume group has been lled with PVs, dene the LVs which the operating
system should use in the next dialog. Choose the current volume group and change to
the Logical Volumes tab. Add, Edit, Resize, and Delete LVs as needed until all space
in the volume group has been occupied. Assign at least one LV to each volume group.
Advanced Disk Setup 51