User Manual

SYMBOL MEANING
D Measurement was made in the field.
I
The reported value is between the laboratory method detection limit and the laboratory practical
quantitation limit.
J1 The sample matrix interfered with the ability to make any accurate determination.
J2 No Quality Control criteria exist for the component.
^ analysis conducted outside the Laboratory's scope of accreditation
L Off scale high. Actual value is known to be greater than value given.
O Sampled, but analysis not performed.
Q Sample held beyond the accepted holding time.
U
Indicates that the compound was analyzed for but not detected. The reported value is the method
detection limit.
V Analyte was detected in both sample and associated method blank. Data may not be accurate.
Y The laboratory analysis was from an improperly preserved sample. The data may not be accurate.
Z
Too many colonies present (TNTC); the numeric value given represents the upper end of the value
that can be determined based on the volume.
? Data are rejected and should not be used. QC data did not meet acceptance criteria.
** Analysis of analyte submitted to an accredited sub-contract laboratory.
! Data deviate from historically established concentration range.
# BCS Lab specific qualifier. See laboratory analysis notes.
DATA QUALIFIER CODES
Final Report BCS ID 1805322, 1805323, 1805326, 1805327 Revision #0, 06/06/2018
4609 NW 6th Street, Ste. A, Gainesville, Florida 32609
BCS Laboratories, Inc. – Gainesville
www.microbioservices.com
Tel. [phone], Fax. [phone]
FL DOH #E82924, ISO/IEC 17025:2005 L2422 (ANAB), PA DEP# 68-03950, EPA# FL01147
This report shall not be reproduced, except in full, without the written consent of BCS Laboratories
Client: Survivor Filter
Page 5 of 5
Project: Purifier Initial Parasite Filtration Efficacy Testing