User Manual

The Survivor Filter Personal Water Filter

Cleaning and Storage

1. Disassemble components.

2. Backwash the Ultra Filter with clean, fresh water.

Backwashing can be done by holding the

Ultra Filter under

clean, filtered water from a tap.

3. Rinse Cotton Pre-Filter and Carbon Filter in clean, fresh water.

4. Air dry and then reassemble.

DO NOT use commercial cleaning solutions or chemicals to

clean your Survivor Filter as they may damage the delicate

filters and components.

1. Disassemble components.

2. Soak the Ultra Filter in Vinegar for 20 minutes.

3. Remove from vinegar and rinse/flush with clean, fresh water.

4. Air dry and then reassemble.

DO NOT soak the Carbon Filter in vinegar as this

will shorten the life of the Carbon Filter.

After prolonged use or before storing your Survivor Filter,

the Ultra Filter should be cleaned with vinegar.

Store your Survivor Filter in a clean, dry place. Avoid

exposure to direct sunlight and store away from excessive

heat sources.

SURVIVOR FILTER