Use and Care Guide
4
See Figures 1 - 2.
1. The 9 ft. PW extension wand can be used when partially
or fully extended.
2. Installing angled extension wand (included) or quick connect accessories (not included):
For partial extension:
Place threaded end of handle assembly (A) into the
connector of the extension with coupler (C). Turn the
extension clockwise until it stops. Tighten securely.
Turn off the pressure washer and shut off the water supply. Pull trigger to release water
pressure.
Engage the lock out on the trigger handle by pushing up on the lock out until it clicks into the
slot.
Pull back the quick-connect collar.
Push the angled extension wand, nozzle or other quick-connect accessory into spray wand
coupler until it clicks.
Push the collar forward so that the nozzle is secured properly.
For full extension:
Place threaded end of handle assembly (A) into the
connector of the extension (B). Turn the extension
clockwise until it stops. Tighten securely.
Install extension with coupler (C) onto extension (B).
Tighten securely.
ASSEMBLY INSTRUCTIONS
2
Push the nozzle into place
Pull back the
quick-connect collar
Push the
collar forward
25
Nozzle
“Click”
Quick-connect
collar
Spray wand
OPERATING INSTRUCTIONS
If your pressure washer hose DOSE NOT
have a quick disconnect coupler on the end
of the hose, connect the hose directly to the
to the water inlet on the handle of the 9 ft.
PW extension wand as shown in figure 3.
Turn on the water supply and start the
pressure washer.
Before attempting to use the 9 ft. PW
extension wand on your project, move away
from the project area. Squeeze the trigger
to release a stream of water so that you can
get a feel for how the unit will perform
during use.
The spray wand will kick back when the
trigger is squeezed or released. Before
releasing the trigger, move the nozzle at least 10 feet away from the surface being cleaned and
make sure you have solid footing.
If your pressure washer hose HAS a quick
disconnect coupler on the end of the hose,
you will need to purchase a quick disconnect
plug. Screw the quick disconnect plug onto
the water inlet of the 9 ft. PW extension
wand as shown in figure 4.
4
High pressure hose
Handle
assembly
Water inlet
Quick disconnect plug
3
Pressure hose
Handle
assembly
Water inlet
www.surfacemaxx.com