Use and Care Guide

ManualsBrandsSurfaceMaxx Pro ManualsPressure Washer AccessoriesSGY-PWA77

15-in Pressure Washer Surface Cleaner

INSTRUCTION SHEET

ITEM #0936072

MODEL #SGY-PWA77

HEAVY DUTY STAINLESS STEEL CONSTRUCTION

ATTACHYOUR RECEIPT HERE

Purchase Date

service department at +1 (866) 870-9930, 9 a.m. - 5 p.m., EST, Monday - Friday.

www.surfacemaxx.com

Questions, problems, missing parts? Before returning to your retailer, call our customer

Summary of content (5 pages)

PAGE 1
ITEM #0936072 INSTRUCTION SHEET 15-in Pressure Washer Surface Cleaner HEAVY DUTY STAINLESS STEEL CONSTRUCTION MODEL #SGY-PWA77 ATTACH YOUR RECEIPT HERE Purchase Date Questions, problems, missing parts? Before returning to your retailer, call our customer service department at +1 (866) 870-9930, 9 a.m. - 5 p.m., EST, Monday - Friday. www.surfacemaxx.
PAGE 2
TABLE OF CONTENTS Product Specifications ............................................................................................................... 2 Safety Instructions ..................................................................................................................... 3 Intended Use ............................................................................................................................. 3 Recommendation ............................................. ...............
PAGE 3
SAFETY INSTRUCTIONS WARNING: When using this product basic precautions should always be followed, including but not limited to the following: 1. Observe the safety instructions of your pressure washer. 2. The Surface Cleaner must not be used by children. 3. Only trigger the gun of the pressure washer if the Surface Cleaner is on the surface to be cleaned. 4. Keep all persons/animals clear of the immediate vicinity of the cleaning head. 5. Keep hands away from moving parts. 6.
PAGE 4
OPERATION See Figure 2. 1. Squeeze the trigger and moving the surface cleaner back and forth and / or side to side begin to cleaning. 2. Never operate in the same area for more than 2 seconds, damage may occur. NOTE: If striping or swirling occurs: 1. Slow your pace and try cleaning the area by going back and forth and side to side. 2. Try overlapping when cleaning by 50%. NOTE: Always squeeze the gun’s trigger to release any residual pressure immediately after use. Engage the trigger lock when not in use.
PAGE 5
REPLACEMENT PARTS LIST PART 1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17 18 19 20 21 22 23 DESCRIPTION Inlet Plug Swivel Valve Spring Fixed Seal Protection Ring Manifold Body Bearing Snap Ring Bottom Plate Brush Screw Shaft Snap Ring O-ring O-ring Locking Pin O-ring Screw Washer O-ring O-ring Spray Bar End Plug QTY 1 1 1 1 1 1 2 1 1 1 4 1 1 1 1 2 1 1 1 2 2 1 2 18 20 19 1 21 2 11 6 PART 24 25 26 27 28 29 30 31 3 17 16 4 15 14 5 13 DESCRIPTION Spray Tip SS Shroud Nut Washer Screw Wheel Support B