Instructions / Assembly

S
TEP
2
Slots for
Fasteners
water-proofing
(SAF
or similar)
plate and over any
sub-floor area.
©
Copyright 2004
2016
SureSill, Ltd. All rights reserved.
Install assembled SureSill
TM
Sloped Sill
rough opening, and secure to rough
opening by fasteners in slots provided.
STEP 5
Install WRB in shingle fashion, including over jamb flashing
and head flashing. ALLOW FREE DRAINAGE FOR SURESILL
SLOPED SILL PAN AND HEADFLASH DURING AND AFTER
CONSTRUCTION. PAINTING IS RECOMMENDED FOR THE SURFACES
EXPOSED TO EXTERIOR. APPLY FOAM TO THE INTERIOR SIDE TO SEAL
THE GAP BETWEEN THE FRAME/JAMB AND THE ROUGH OPENING ON
THREE SIDES (TWO VERTICAL AND ON TOP).
S
TEP
1
Install
Drainage S
kirt
plate over any sub-floor area. See
Sealing the Sill Pan STEP 1 DETAIL
Apply sealant on
concrete, sub-
floor or
the sides.
STEP 4
Install window or door per OEM instructions. See STEP 4 DETAIL Install
the HeadFlash
TM
. Install HeadFlash
TM
head flashing.
Apply SAF over the HeadFlash
TM
S
TEP
3
Use self adhering flashing (SAF) on
rough jamb, over SureSill
TM
End Caps.
Apply adhesive sealant to jambs and
head.
Adhesive
Sealant
(over SAF
and head)
threshold with sealant and tool it flat.
Back of the door/window casing should be grooved to
accommodate for the sill pan.
THE SURE
LEVEL OF
PROTECTION
Page 2 of 3
*1
NOTE:
SURESILL SLOPED SILL
PAN AND SURESILL
HEADFLASH SHOULD BE
INSTALLED AT THE SAM
E TIME
A WINDOW OR DOOR IS
BEING
INSTALLED.