Manual

Model M2 Centurion Flashlight
Introduction
The Centurion uses the P60 High Pressure Xenon Lamp Assembly to produce
a superlative beam rated at 65 lumens. Powered by two lithium Duracell
DLl23A batteries, it has a run time of one hour. The brighter P61 Lamp Assem-
bly, produces 120 lumens at a shorter run time of 20 minutes. Both lamp
assemblies are furnished standard with the Centurion.
The Model M2 Centurion incorporates features that make it the ultimate Per-
sonal Defense Light. Waterproof, with stainless steel pocket clip, it features the
SURE-FIRE lock-out tail cap switch which disables the light from activation
during transport, storage or operations. This Tail Cap allows for Momentary
use, constant ON and Disable. The octagonal bezel keeps the light from rolling
on non-level surfaces, and holds a Pyrex, scratch resistant window. The Centu-
rion also features an ergonomic, flat-sided body and rubber grip ring, which
provides an excellent grip, similar to that on our CombatLights. Precision
machined from solid aircraft grade aluminum, the Centurion has mil-spec Type
3 hard anodizing, giving it increased ruggedness and resistance to wear over
the years. Each SURE-FIRE lamp assembly is individually focused at the
factory, bonded in its reflector, to assure a perfect, flawless beam.
Kit Contents
! Centurion Flashlight
! P61 Lamp Assembly
! DL123A Battery (2)
! Users Manual
Installation
1. Remove the Bezel and Lamp Assembly from the Flashlight by unscrewing the
Bezel (counterclockwise) until it comes off theFlashlight.
2. Install the two batteries with the + terminal facing out.
3. Re-install the Bezel and Lamp Assembly by placing the Lamp Assembly
inside the Bezel and then screwing the Bezel (clockwise) onto the Flashlight
Body until it is seated.
4. DO NOT TOUCH the reflector or Lamp surfaces. The oil from your skin can
degrade the surfaces and reduce the performance of your flashlight.