Model 617P Benelli Tactical Light Users Manual Benelli Shotgun M1 Super 90 12 Gauge Serial No. M104801 and later Protected by US.
Model 617P Tactical Light Introduction The Model 617P Tactical Lights provide a rugged and reliable source of high intensity light that is integrated into the fore-arm of the shotgun. The lamp is shock isolated. The H17P Housing has a Pressure Switch on the right side. A second Pressure Switch is attached to the Pistol Grip. The switches are wired in parallel. Press on either Pressure Switch and the light will come ON, release pressure and light will go OFF.
Sure-Fire LLC
Model 617P Tactical Light 12. Remove paper backing from Cable Clamps and press in place. Slip cable into clamps. 13. Install Battery into Housing with the + terminal facing out. 14. Install Lamp Module into Housing. 15. Apply finger pressure to the Pressure Switch on the right side of the Housing. The light should come on. Installation is now complete. 16. Test fire the weapon to insure that the boresight has not changed. A shift in pointing may occur after installing the Tactical Light on the weapon.
Model 617P Tactical Light Caution The battery used in the light is very powerful. Be sure that the switch is not touching anything when the light is stored. If the lamp is turned on while in a case or other container, the lamp can overheat and damage the light or surrounding materials. Remove the battery or unscrew the bezel far enough to prevent the lamp from turning on when stored.
