Model 340 640 Sig Sauer Tactical Light Users Manual P228 & 229 9mm Revision B 11-1-95
Model 340 & 640 Waterproof Tactical Light Introduction The Model 340 & 640 Tactical Lights provide a rugged and reliable source of high intensity light mounted below the barrel of the weapon. The light can be activated by pressing on the Pressure Switch attached to the handgrip or by pushing forward on the Switch Actuator Plates on the sides of the Housing. Installation 1. Remove the magazine from the weapon and inspect the weapon to be certain it is not loaded. 2.
Model 340 & 640 Waterproof Tactical Light Kit Contents ! H40 Housing & Takedown Latch ! L30 or L60 Lamp Module ! DL123A or DL223AC Battery ! Velcro Hook & Loop ! Extra Set Screw ! Hex Wrench ! Alcohol Wipe ! Users Manual * Additional set screws are available in a Ten Pack, order P/N 12010-1. Lamp Replacement 1. Unscrew Bezel from Lamp Module. Lift Lamp assembly out of Bezel. 2. Install replacement Lamp Assembly inBezel and reassemble by screwing onto Lamp Housing until it is fully seated.
Sure-Fire LLC
Model 340& 640 Tactical Light Caution The battery used in the light is very powerful. Be sure that the switch is not touching anything when the light is stored. If the lamp is turned on while in a case or other container, the lamp can overheat and damage the light or surrounding materials. Remove the battery or unscrew the bezel far enough to prevent the lamp from turning on when stored. Do not use a 3 Volt Lamp Assembly in a 6 Volt system.
