Manual
Model 307 & 607 Tactical Light
Introduction
The Model 307 & 607 Tactical Lights provide a rugged and reliable source of high intensity
light mounted below the barrel of the weapon. There are two switches that can be used to activate
the light. Press on the Pressure Switch attached to the handgrip, the light will come ON and stay
ON as long as pressure is applied. Operate the ON/OFF Switch on the left side of the Housing and
the light will come and stay ON until the OFF switch is pressed.
Kit Contents
! H07 Housing & Slide Stop
! L30 or L60 Lamp Module
! DL123A or DL223AC Battery
! Velcro Hook & Loop
! Extra Set Screw
! Hex Wrench
! Alcohol Wipe
! Users Manual
* Additional set screws are available in a Ten Pack, order P/N 12010-11.
Installation
1. Remove the magazine from the weapon and inspect the weapon to be certain it is not loaded.
2. Disassemble weapon far enough to remove slide stop.
3. Position H07 Housing so that hole in side is aligned with slide stop hole on the frame.
4. Install new Slide Stop.
5. Reassemble weapon as necessary.
6. Using the Hex Wrench provided in the Kit, tighten the Set Screw in the base of the Housing
until it contacts the trigger guard then turn the set screw out 1/8 turn so as not to put tension
on the Slide Stop. After firing 500 rounds the Set Screw may loosen, remove it and install the
extra Set Screw provided in the Kit.*
7. Select the location desired on the weapon for mounting the Pressure Switch.
8. Using the Velcro provided in the Kit, remove the paper backing from the “loop” section of
Velcro and press in place on clean area. Wipe with alcohol first!
9. Wipe the rear (flat) side of the Pressure Switch with alcohol to remove oil & dirt.
10. Remove the paper backing from the Velcro “hook” and press it in place on the rear side of
the Pressure Switch.
11. Using Velcro, position the Pressure Switch on the weapon. Route the cable so that it does
not interfere with the weapon operation.
12. Install the battery with the + terminal facing out.
13. Install the Lamp Module Assembly. Unit is now ready for use.