Model 307 607 Para-Ordnance Tactical Light Users Manual Para-Ordnance Pistols .45 caliber Protected by US.
Model 307 & 607 Tactical Light Introduction The Model 307 & 607 Tactical Lights provide a rugged and reliable source of high intensity light mounted below the barrel of the weapon. There are two switches that can be used to activate the light. Press on the Pressure Switch attached to the handgrip, the light will come ON and stay ON as long as pressure is applied. Operate the ON/OFF Switch on the left side of the Housing and the light will come and stay ON until the OFF switch is pressed.
SureFire LLC
Model 307 & 607 Tactical Light Lamp Replacement 1.Unscrew Bezel from Lamp Module. Lift Lamp assembly out of Bezel. 2.Install replacement Lamp Assembly in Bezel and reassemble by screwing onto Lamp Housing until it is fully seated. Battery Replacement 1.Unscrew Lamp Module from Housing and shake out old battery. 2.Install new battery with the + terminal facing out. 3.Reinstall Lamp Module.
Model 307 & 607 Tactical Light Caution The battery used in the light is very powerful. Be sure that the switch is not touching anything when the light is stored. If the lamp is turned on while in a case or other container, the lamp can overheat and damage the light or surrounding materials. Remove the battery or unscrew the bezel far enough to prevent the lamp from turning on when stored. Do not use a 3 Volt Lamp Assembly in a 6 Volt system.
