User Manual

7
SureCall | 48346 Milmont Drive, Fremont CA 94538 | 1-888-365-6283 | [e-mail]
7
LED Indicators
IntheeventRedLEDsappeareithersolidorashing,furtherseparationbetweentheboosterand
outside antenna is recommended.
Note that the booster case may become warm during operation. This is normal.
WARNING. The booster is rated for 5-15V input voltage. DO NOT use the booster with a higher voltage power supply. This can damage the
booster and/or cause personal injury.
LED Indicators
Troubleshooting
Problem Resolution
Signal booster
has no power
Verify that the Power LED on the booster is ON.
Connect the power supply to an alternate power source.
Verify that the power source is operational and the fuse is intact.
If the POWER LED on the signal booster is OFF, return the power supply to SureCall. Contact tech support
at to receive an RMA at:
1-888-365-6283 or [e-mail], or go to www.surecall.com, 7:00 am – 5:00 pm PST, Monday –
Friday to chat with a representative.
After completing
installation,
signal has not
Improved
Verify that cable connections are tightly tted to the booster.
Try further separating the antennas.
 Remember: Bars are not always a reliable measure of signal. The best way to conrm signal coverage is
the ability to place and hold a call.