User Manual

6
SureCall | 48346 Milmont Drive, Fremont CA 94538 | 1-888-365-6283 | [e-mail]
6
Step 2. Install the Signal Booster
1. Connect the inside whip antenna to the port on the side of the booster labeled “INSIDE”.
2. Mount the booster within a cabinet or on a side panel close to a power source. Note that the
Inside antenna and sends signal in a 360 degree radius. The antenna should be aimed vertically.
The location you select should generally be in the center of where signal is needed and also
avoid excessive heat, direct sunlight, or moisture, as well as, provide proper ventilation.
3. Route the cabe from the outside antenna inside and connect to the port on the booster labeled
“OUTSIDE”.
Step 3. Connect Power
Connect the DC power adapter to the signal booster and plug into power outlet. The Power LED will
light, indicating that the signal booster is ready for use.
Installation
Power Connection
Connector to Inside Antenna
Connector to Inside Whip antenna
Connector to Outside antenna