FusionProfessional Cellular signal booster kit for the Home or Office User Guide 11.23.
Introduction Thank you for purchasing SureCall’s Fusion Professional cellular signal booster kit. SureCall’s Fusion Professional was specifically designed to eliminate frustrations over dropped calls and limited range by amplifying incoming and outgoing cellular signals in homes and offices. If you have any questions during setup, please reach out to our US-based experienced support technicians: Call: 1-888-365-6283 Email: support@surecall.com Visit: www.surecall.
Table of Contents TABLE OF CONTENTS How it works ...................................................................................................................................... 4 PACKAGE CONTENTS......................................................................................................................... 4 BEFORE INSTALLATION...................................................................................................................... 6 Installation Overview........................
How It Works How it works 1. An outside antenna collects signal from the cell tower. 2. The antenna sends the signal to the booster through coax cable. 3. The booster amplifies the cell signal and rebroadcasts the signal indoors via the inside antenna to all mobile devices within range. 4. The system also works in reverse amplifying outgoing signal back to the tower.
Package Contents Your Fusion Professional signal booster package includes the following items: 1. SureCall FusionPro signal booster and power supply 2. Outside Yagi Antenna - SC-230W 3. Outside cable (50 ft) to connect the booster and outside antenna SC-400 4. Inside panel antenna -SC-248W 5. Inside cable (20 ft) to connect the booster and inside antenna - SC-240 1. Fusion Professional Booster and power supply 2. Outside Antenna: Directional Yagi Antenna 3. O utside Cable (50 ft) 4.
Before Installation BEFORE INSTALLATION 1. Prior to securing the location of any booster parts, a “soft install” is recommended as adjustments may be needed to optimize performance. 2. Ensure adequate separation between the planned locations of the inside and outside antenna – at least 25 ft (see diagram ”Antenna Separation” on page 7). 3.
Installation For specific dB signal measurements, use the methods below. • Apple iPhones: Dial *3001#12345#* and press Call. In the top-left corner, a dB number appears instead of bars. • Android devices: download the app “Network Signal Info” in the Google Play store. Step 2. Install the Outside Antenna After identifying the area of strongest signal, choose the surface where you will mount your outside antenna.
Installation Step 3. Install the Booster and Inside Antenna Choose a location for the booster and inside antenna that is near a working outlet and at least 25 Ft from the outside antenna. Consider the below factors affecting booster performance. 1. Signal strength at the location of the outside antenna. 2. Interior building materials between the inside antenna and your mobile device. 3. Distance between the outside antenna and inside antenna (minimum 25 ft. separation).
Installation Place the Booster To install the booster to a wall, select a location that is near a working AC outlet. Use the supplied screws or appropriate screws for surface of mounting location and drill through screw tab holes on booster (see “Booster Diagram” illustration) and mount the booster to a wall. Next, connect the outside antenna and booster by connecting the open end of the 50 ft. cable leading from the outside antenna to the port of the booster marked “OUTSIDE”.
Troubleshooting Check and Optimize System, if Needed Place a call and walk throughout your space to confirm that your phone is receiving a boosted signal. If indoor coverage is limited, consider the following factors: 1. Signal strength at the location of the outside antenna. Coverage area is directly related to the strength of incoming signal received by the outdoor antenna. If signal is weak where the outside antenna is installed, indoor coverage will be limited. 2.
LED Indicators LED INDICATORS The gain dials on the booster should always be at maximum level unless a control light is flashing red-yellow. Additionally, they should only be reduced if other recommended actions do not resolve the issue. Condition Indication/Status Indication/Resolution Initializing on Power-up All control lights flash RED & YELLOW for 5 seconds then off for 5 minutes.
Specifications Consider the following options to resolve issues with inadequate antenna isolation. 1. 2. 3. 4. Verify that a minimum distance of 25 vertical feet has been achieved. Separation up to 40 - 50 ft may be needed, however, especially where vertical separation is not possible. Check for sources of interference such as, cellular modems or hotspots. Verify neither antenna is placed near a window. Ensure that the antennas are aimed away from one another.
Kitting SPECIFICATIONS Model Fusion Professional Uplink Frequency Range (MHz): 698-716 / 776-787 / 824-849 / 1850-1915 / 1710-1755 Downlink Frequency Range (MHz): 728-746 / 746-757 / 869-894 / 1930-1995 / 2110-2155 Maximum Gain: 72 dB Supported Standards: CDMA, WCDMA, GSM, EDGE, HSPA+, EVDO, LTE and all cellular standards Max Uplink Power: 26.
Consumer Guidelines CONSUMER GUIDELINES This is a CONSUMER device BEFORE USE, you MUST REGISTER THIS DEVICE with your wireless provider and have your provider’s consent. Most wireless providers consent to the use of signal boosters. Some providers may not consent to the use of this device on their network. If you are unsure, contact your provider.
Warranty WARRANTY Three-Year Product Warranty To activate your three-year manufacturer’s warranty, register at www.SureCall.com/activate SureCall warrants its products for three years from the date of purchase against defects in workmanship and/or materials. Specifications are subject to change. The threeyear warranty only applies to products meeting the latest FCC Certification Guidelines stated on 2/20/2013 and going into effect April 30, 2014.
SureCall, Inc 48346 Milmont Drive Fremont, California 94538, USA 888.365.6283 | www.surecall.
