User Manual

SureCall Fusion2Go 3.0 FleetSureCall Fusion2Go 3.0 Fleet
www.SureCall.com | 1-888-365-6283 | [e-mail]8
LED Indicators
Place a call in a location you have previously experienced poor signal and conrm that your
phone is receiving a boosted signal. Normal operation is indicated by Green LEDs (both
ashing and solid). In the event Red LEDs appear, antenna adjustments may be needed.
Color Condition Indication
Green Solid Indicates normal operation.
Green Flashing Normal operation. Indicates that Automatic Gain Control (AGC) is self-
adjusting due to over-signal or antenna proximity.
Red Flashing Indicates issues caused by overpowering or oscillation.
Adjustment of your outside antenna placement is likely needed. Verify that it has
sufcient separation from the inside antenna, as well as, any potentially interfering
objects or antennas
Note that the booster case may become warm during operation. This is normal.
Troubleshooting
Problem Resolution
Signal booster has
no power
1. Verify that the Power LED is ON.
2. Connect the power supply to an alternate power source.
3. Verify that the power source is operational and the fuse is intact.
4. If it remains OFF, contact tech support at:
1-888-365-6283 or [e-mail]
After completing
installation, signal
has not Improved
Verify that cable connections are tightly tted to the booster.
Try further separating the antennas.
 Note: Bars are not always a reliable measure of signal. The best way to
conrm signal coverage is the ability to place and hold a call.
* WARNING: The booster is rated for 5-15V input voltage. DO NOT use the booster with a higher voltage power
supply. This can damage the booster and/or cause personal injury.