User Guide

SureCall Fusion2Go 3.0 Fleet
www.SureCall.com | 1-888-365-6283 | [e-mail] 7
LTE-A
LTE-V
CELLULAR
PCS
AWS
POWER
Power
Connector
Step 4. Connect Power
Before and while wiring the power supply, disconnect vehicle battery. Hardwire installation
requirements vary by vehicle. The following is only a general guide. Check with your
manufacturer’s vehicle for specic electrical placement or requirements.
Locate a +12V accessory (“ACC”) wire that will switch on and off with the ignition. Connect to
the power source and ground.
Once connections are complete, verify operation by connecting the DC power cord
connector to the signal booster. The Power LED on the signal booster will illuminate to
indicate it is receiving power and is ready for use. Permanently secure power cable.
Connect the power cord connector to the signal booster and insert the other end into your
cigarette lighter adapter
1
.
The Power LED illuminates to show that the signal booster is ready for use. The Alert LEDs
ash 5 times to show the frequency band is operational.
Place a call in a location you have previously experienced poor signal and conrm that your
phone is receiving a boosted signal.
[1] WARNING: The booster is rated for 5-15V input voltage. DO NOT use the booster with a higher voltage power
supply. This can damage the booster and/or cause personal injury.