How to Guide

SureCall | www.surecall.com | 1-888-365-6283 | [e-mail]
5
Step 1: Mount Outside Antenna
Place the magnetic-mount antenna on the top of your vehicle, preferably toward the back, maximiz-
ing the distance from planned location of the inside patch antenna. Ensure that the antenna has at
least a 12-inch radius clear of obstructions and other radiating elements, such as a radio antenna.
Note, For applications that require a more secure mount or where mounting surface is not metal,
an optional adhesive mount has also been included with your kit. Follow these guidelines for use of
adhesive mount:
• Always clean the surface properly. Apply the tape as soon as possible after cleaning to avoid contaminants
• Use an adequate amount of tape
• Ensure that all materials meet the required minimum tape application temperature of 15°C
• Roll down tape rmly both after tape application and then again after parts are bonded together
Next, run the cable from the outside antenna across the car’s roof and into the car. To hide and pro-
tect the antenna cable, carefully pull down the door seal, run cable underneath it and push the seal
back into place. Run the cable to the inside of the vehicle near the planned location of the booster
(under the seat of the vehicle, or in the front or middle console).
Note: The outside antenna must not be collocated or operating with any other antenna or booster.
Step 2. Install the Inside Patch Antenna
Identify a location for the inside antenna on or near your front dash-
board that is
1. Within 2-3 feet of the typical cell phone location
2. At least 8 inches (20cm) from cellular devices and
3. At least 4 inches (10cm) from metal
Installation