Manual

SureCall | www.surecall.com | 1-888-365-6283 | [e-mail]
8
Step 3. Place the Booster
Place the booster in a central location where signal is needed
and at least 25 ft. from the outdoor antenna location. When
placing the booster, note that further separation between
the booster and outside antenna will increase booster
performance. Connect the open end of the RG6 cable from
the outside antenna to the booster and tighten connection.
Please note that the performance and range of your booster
depends on three factors:
1. Signal strength at the location of the outside antenna.
2. Interior building materials between the booster and
your mobile device.
3. Distance between the outside antenna and booster
(while at least 25 ft. separation is recommended, further
separation will increase performance).
Step 4: Connect to Power
Once the booster and outside antenna are connected and in
place, connect the power cord to the signal booster and plug
into a power outlet.
Enjoy Boosted Signal
Place a call in the room where the booster is located to
conrm that your phone is receiving a boosted signal.
Remember: Bars are not always a reliable measure of signal.
The best way to conrm signal coverage is the ability to place
and hold a call.
Installation
Placing Booster and connecting cable
Connecting the Power Supply
Note: This booster is rated for 5-15V input voltage. DO NOT use the booster with a higher voltage power supply. This can damage the booster, cause personal injury,
and void your warranty.
This booster should not be used near open re or ame. Storage and transportation: Store and place in non-extreme room-temperature and dry environment.