Manual

SureCall | www.surecall.com | 1-888-365-6283 | [e-mail]
7
Step 2. Install the Outside Antenna
After identifying the area of strongest signal, choose the surface where you will mount the outside antenna.
Using the provided hardware, mount the outside antenna at the highest possible elevation, allowing a minimum separation
of 25 feet from the planned location of the booster.
Do not collocate antennas or operate the outdoor antenna with any other antenna or signal booster.
Outside Yagi Antenna Installation
Before installing a Yagi, or directional antenna, note that the antenna should be
mounted on a pole or pipe (not provided), at the highest possible location and
mounted horizontally, aimed in the direction of your nearest cell tower. To nd the
location of your carrier’s closest cell tower, go to www.antennasearch.com.
Ensure that the mounting area has at least a 12-inch radius clear of obstructions and
other radiating elements and orient the antenna with the drip hole at the bottom.
Once you have identied your install location, assemble the u-bolt, bracket, nuts
and washers onto a pole or pipe (not provided) as shown in the illustration. Keep
the connections loose enough to allow the antenna to rotate until the optimum
direction is found.
Once the outside antenna is secured to a pipe or pole, connect antenna to one end
of the provided RG6 cable and tighten the connection. Run the cable along route to
planned location of your booster.
Note: Avoid placing either component (booster or outside antenna) near windows where possible as it increases the
potential for oscillation.
Installation
Yagi Antenna
MountIng hardware
Nut
Washer
U-bolt
Bracket
Drip Hole
RG6 Cable
Cable
Planned
Booster
Location
Outside
Antenna
min
i
mum
2
5 f
t.
sep
a
rat
i
o
n
Yagi Antenna Install Illustration
Outside Antenna Assembly