Technical Guide

CAUTION: VERIFY THAT ALL INTERIOR ANTENNAS MEET
THE SEPARATION REQUIREMENTS DESCRIBED IN THE
PREVIOUS CHAPTER, AND THAT NO ANTENNA IS AIMED
TOWARD THE EXTERIOR ANTENNA.
CAUTION: DO NOT CONNECT AN INTERIOR ANTENNA TO THE
SPLITTER INPUT.
4.3 Interior Antennas
Mount the interior antenna(s) in the location(s) you selected when planning. Follow all instructions included with the antenna(s) to ensure
the installation(s) are done properly.
Here are a few reminders and essential steps:
• Dome antennas are mounted on the ceiling as close to the center of the desired coverage area as possible, domed (convex) side
pointing down.
• Flat panel antennas should be wall-mounted as close as possible to the center of the wall, or at one end of long narrow space.
• Mount the antenna.
• Connect a length of cable to the antenna and tighten until hand-tight.
• If you are installing multiple antennas, run the cable to the splitter location and connect the cable to one of the outputs on the splitter.
• Connect another length of cable to the input side of the splitter (if used) and run this cable to the BDA location.
• It is important to keep the cable runs equal or use taps to ensure a harmonious install.