User's Guide

SureCall | 48346 Milmont Drive, Fremont CA 94538 | 1-888-365-6283 | [e-mail]
14
Chapter 4: Installation
4.4 Mounting the BDA
Mount the booster as follows:
• Verify that the selected location meets all criteria described in the previous chapter.
• Attach the included mounting kit to the booster using the screws provided. Tighten the screws by hand with a
screwdriver until tight plus 1/4 to 1/2 turn. Do not over-tighten.
• Mount a 24 inch x 24 inch x 3⁄4 inch thick sheet of plywood on top of sheetrock, secured into wall studs where the
booster is to be placed. The plywood should be ush against wall.
• Once the plywood is secure, attach booster to the plywood base using the screws provided. In most installations,
the housing will be oriented so the I/O ports are facing down.
• Connect the outdoor antenna cable to the signal booster connector port marked OUTSIDE and tighten the
connection.
• Connect the outdoor antenna cable to the signal booster connector port marked INSIDE and tighten the
connection.
CAUTION: DO NOT POWER ON THE BDA
UNTIL INSTRUCTED TO DO SO.
CAUTION: NEVER POWER ON THE BDA
WHEN ANY ANTENNAS ARE DISCONNECTED
AS THIS COULD DAMAGE THE BDA.