User's Manual

SureCall | 48346 Milmont Drive, Fremont CA 94538 | 1-888-365-6283 | [e-mail]
76
Installing Your Hardware
Step 3: Attach the N-Female connection from the interior antenna to the cable leading to
the connector labeled INSIDE, on your booster.
Step 4: Tighten xing nut to secure antenna (do not over-tighten).
• Storage and transportation: Store and place in non-extreme room-temperature and
dry environment
• Attention: This antenna should not be used near open re or ame
Dome antennas are omni-directional interior antenna that gather signals from all sides.
Range of antennas is dependent on three factors:
1) Physical obstructions
2) Power generated by booster and
3) Reception from outside signal received and
distributed by outside antenna.
Dome antennas should be mounted in
an upright position for best results.
Step 1: Drill a 35mm diameter hole in the ceiling. The ceiling
thickness should be 20mm, maximum.
Step 2: Unscrew xing nut from antenna. Place antenna cable
through hole. Screw the xing nut back onto antenna
and cable on crawl space side of ceiling and fasten.
Installing Your Hardware
Step 2. Install the Signal Booster
1. Select a location for your booster close to a working AC outlet. Do not expose the signal
booster to excessive heat, direct sunlight, moisture, and airtight enclosures.
2. Attach the supplied mounting kit to the booster using the supplied screws. Tighten the
screws with a screwdriver until snug, then add a 1⁄4-to-1/2 turn. Do not over tighten.
3. Orient the signal booster so the LEDs and DIP switches face away from the wall and
the LEDs are seen easily. Then mount the signal booster to the wall using appropriate
screws and/or wall anchors.
4. Connect the main cable line from the primary booster to the booster’s connector labeled
“Outside”. Hand-tighten the connection.
5. Connect the inside antenna cable to signal booster marked INSIDE. Hand-tighten the
connection.
6. Connect the AC power cord to the signal booster.
7. Connect the plug on the other end of the 110V AC power outlet.
8. Turn the booster’s power switch on.
• The signal booster turns on automatically.
• The Power LED lights up to show that the signal booster is ready for use.
• The Alert LEDs ash up to 15 seconds on each band to show the band is activated.
Note: If the Power LED does not turn ON or the Alert LEDs continue to ash, see Troubleshooting page 19. This booster is rated for 19V AV input
voltage. DO NOT use the booster with a higher voltage power supply. This can damage the booster, cause persoanl injury and viod your warrenty.
SureCall | 48346 Milmont Drive, Fremont CA 94538 | 1-888-365-6283 | [e-mail]