EZBoost 4G ª Home Signal Booster Kit User Guide
Table of Contents Thank you for your purchase of SureCall’s EZBoost 4G cellular signal booster kit. EZBoost 4G was specifically designed to eliminate frustrations over dropped calls, limited range and slow data rates by amplifying incoming and outgoing cellular signals in homes. EZBoost 4G enhances 2G and 3G voice and reception data for all major U.S. carriers. If you need any assistance while installing this product please contact tech support at 1-888-365-6283 or email us at: support@surecall.com.
How It Works Package Contents SureCall’s EZBoost 4G is a high-quality bidirectional signal booster that 1. Unpack all package contents. For missing or damaged items, contact your reseller. enhances cellular signals to areas that are prone to weak cellular coverage. 2. Turn over the signal booster and record the model and serial number for reference: EZBoost 4G works with two antennas: • An inside desktop antenna that communicates with your cell phone.
Installing Your Hardware Before You Install Step 1. Make sure you have positioned the booster in a window with the strongest signal close enough to an existing electrical outlet. Step 2. Make sure you have sufficient cable length between proposed inside antenna location and booster connector. Installation Overview Step 1. Find the window area that has the strongest signal. (See page 7 for instruction) Step 2. Install the inside antenna. (See page 8 for instruction) Step 3.
Installing Your Hardware Installing Your Hardware Step 3. Install the Inside Antenna Step 4. Install the Signal Booster For areas of 1000 square feet and below allow 30-35 feet of separation between the booster and the desktop antenna. 1. Select a location close to a working AC outlet. Do not expose the signal booster to excessive heat, direct sunlight, moisture, and airtight enclosures.
Installing your Hardware Troubleshooting Booster Hardware Step 5. Configure Gain Settings The following image shows the key hardware components on the cellullar booster. Refer to this image as you install your EZBoost 4G kit components. 1. Find the PCS, Cellular, and LTE/AWS dials on top of the signal booter. 2.
Troubleshooting Specification Problem Resolution Specification EZBoost 4G LED flashing yellow This means that the Automatic Gain Control (AGC) is adjusting which is part of the boosters normal operation Uplink Frequency Range (MHz): 824-849 / 1850-1910 Downlink Frequency Range (MHz): 869-894 / 1930-1990 Supported Standards: CDMA, WCDMA, GSM, EDGE, HSPA+, EVDO, LTE and all cellular standards Input/Output Impedance: 50 ohm Maximum Gain: 65dB-Cellular / 72dB- PCS Noise Figure: 7dB Each Sure
Warranty Warranty Three-Year Product Warranty SureCall warrants its products for three years from the date of purchase against defects in workmanship and/or materials. Specifications are subject to change. The three-year warranty only applies to products meeting the latest FCC Certification Guidelines stated on 2/20/2013 and going into effect April 30, 2014. A two-year warranty applies to any products manufactured before May 1, 2014.
This is a CONSUMER device. BEFORE USE, you MUST REGISTER THIS DEVICE with your wireless provider and have your provider’s consent. Most wireless providers consent to the use of signal boosters. Some providers may not consent to the use of this device on their network. If you are unsure, contact your provider. You MUST operate this device with approved antennas and cables as specified by the manufacturer. Antennas MUST be installed at least 20 cm (8 inches) from any person.
