User's Guide

SureCall | 48346 Milmont Dirve, Fremont CA 94538 | 1-888-365-6283 | [e-mail]
16
CAUTION: VERIFY THAT ALL INTERIOR ANTENNAS
MEET THE SEPARATION REQUIREMENTS
DESCRIBED IN THE PREVIOUS CHAPTER AND THAT
NO ANTENNA IS AIMED TOWARD THE EXTERIOR
ANTENNA.
CAUTION: DO NOT CONNECT AN INTERIOR ANTEN-
NA TO THE SPLITTER INPUT.
4.4 - Internal Antennas
Mount the interior antenna(s) in the location(s) you selected during the planning process. Be sure to
follow the instructions included with the antenna(s) for a safe installation. Remember:
• Dome antennas (SC-222W, SC-223, etc.) should be mounted in the ceiling as close to the center
of the desired coverage area as possible with the domed side pointing down.
• Flat panel antennas (SC-248W) should be wall-mounted as close as possible to center of the wall
at one end of long narrow space.
1. Mount the antenna.
2. Connect a length of SC-400 or SC-240 cable to the antenna and tighten until hand-tight.
3. If you are installing multiple antennas, run the cable to the splitter location and connect the cable
to one of the outputs on the splitter.
4. Connect another length of SC-400 or SC-240 cable to the input side of the splitter (if used) and
run this cable to the booster location.
5. It is important to keep the cable runs equal or use taps to ensure a harmonious install.
Installation