Installation Guide

SPECIFICATIONS
Overall Dimensions: 11.25" x 11.75" x 2.75”
Capacity: 100 nails
Nail Length: 32 mm- 64 mm (1-1/4”-2-1/2”)
Nail size: 16 Gauge(1.60x1.40mm)
Operating Pressure: 60 - 100 PSI (4-7 bar)
Air Inlet Size: 1 /4” N .P.T
Weight of Tool: 4.14 lbs.
NAIL SELECTION
Use SUREBONDER 500 Series
16 gauge straight finish nails
1-1/4" to 2-1/2".
1/4” Male Quick
Release Connector
Trigger
Rubber Grip
Nail magazine
Nail feeder
Contact Safety Mechanism
Rubber Tip
Adjustable
Exhaust Cover
OPERATION
®
min. 1-1/4" (32 mm)
max. 2-1/2 "(64 mm)
Min Max
5
Loading Nails (continued)
To load:
Insert strip of nails into rear of magazine. Do not load with contact safety mechanism or trigger
depressed. Slide nail strip towards the front of the magazine, making sure strip is past the nail stop.
Pull feeder shoe completely behind the nail strip. Release the feeder and the nail strip will be pushed
to the front of the magazine.
Latch
To remove fasteners: Depress the latch and release the feeder shoe and slide it forward. Remove
fasteners from the tool.
Jam Clearing Depth Adjustment Exhaust Deflector Exhaust
Pull down on latch and swing Using thumb screw to achieve deflector can be positioned to
guide plate outward. Remove desired depth. point in any 360° direction.
jammed nail , replace guide Reposition deflector by
plate catch and lift latch up. rotating to the desired
position.
Nails Loaded
Feeder
Nail stop
16
Gauge