Instructions / Assembly

SPECIFICATIONS
Overall Dimensions: 11.25" x 11.75" x 2.75”
Capacity: 100 fasteners
Operating Pressure: - 100 PSI (4.8-7 bar)
Air Inlet Size: 1 /4”NPT (National Pipe Thread)
Weight of Tool: 5.05 lbs.
FASTENER SELECTION
Use SUREBONDER 500 Series or any other brand
16 gauge - Finishing Nails 1" to 2-1/2” (25mm-64mm)
Use SUREBONDER 400 Series or any other brand
18 gauge - Brad Nails 5/8”to 2” (15mm-50mm)
Use SUREBONDER 350 Series or any other brand
18 gauge - 1/4”Crown Staples 5/8”-1-5/8”
70
(15mm-32mm)
Adjustable
Exhaust Cover
Finishing Nails-Insert in Center Slot
Brad Nails-Insert in Left- Side of Magazine
Staples-Insert staple legs in Center & Side Slot
OPERATION
5
Jam Clearing: Pull down on latch Depth Adjustment: Turn depth Exhaust Deflector: Exhaust
and swing guide plate outward. adjustment dial clock-wise to deflector can be positioned
Remove jammed nail, replace increase depth drive and counter- to point in any 360° direction.
guide plate catch and lift latch up. clockwise to decrease depth Reposition deflector by rotating
drive. (when operator is holding to the desired position.
handle with right hand).
Depth Adjustment Knob
Turn knob clockwise-for more depth
Turn knob counter-clockwise-for less depth
6
Finishing Nail Brad Nail Staple
16 gauge 18 gauge 18 gauge
1”to 2-1/2" (25mm-64mm)
5/8” to 1-5/8”
(15mm-41mm)
5/8” to 2”
(15mm-50mm)
To load Finishing Nails: Detach nailer from air supply.
Do not load with contact safety mechanism or trigger
depressed. Push magazine release to release magazine
and slide back. Insert strip of finishing nails into the
center slot at the top of the magazine. (Fig.1). Slide
magazine cover towards the front of the magazine
until it is locked in place.
To load Brad Nails: Detach nailer from air supply.
Do not load with contact safety mechanism or trigger
depressed. Push magazine release to release magazine
and slide back. Insert strip of brad nails into the left-side
of magazine (Fig.2). Slide magazine cover towards the front
of the magazine until it is locked in place.
To load Staples: Detach nailer from air supply. Do not
load with contact safety mechanism or trigger depressed.
Push magazine release to release magazine and slide back.
Insert strip of staples at the top of the magazine with one
leg of the staple in the center slot and the other leg along
the left-side of the magazine (Fig.3). Slide magazine cover
towards the front of the magazine until it is locked in place.
Trigger
Quick Release
Magazine
1/4” Male Quick
Release Connector
Rubber Grip
Depth Adjustment
Quick Release
Latch
Guide Plate Catch
Contact Safety Mechanism
Nail Magazine
Loading Finishing Nails, Brad Nails, Staples: (See different methods
of loading all 3 fasteners). Note: Load only one type of fastener at a time.
Dial
Fig. 1
Fig. 2
Fig. 3
1/4”