Instructions / Assembly

Disconnect air hose from tool:
before performing maintenance
when clearing a jam
when tool is not in use
when moving it to another location
when handing tool to another person
DO NOT place finger on trigger when disconnecting air hose - the tool could fire when
reconnected to the air supply.
Carry tool by the handle only, not by the air hose.
Do not drive nails/staples close to the edge of the workpiece. It could split, allowing a
nail/staple to fly or ricochet and causing personal injury. Do not try to drive nails/staples
at too steep an angle. Make sure tool is held firmly during firing to minimize recoil.
Do not drive a nail/staple into very hard material, thin material, or on top of an existing
nail/staple- the nail or staple could ricochet, causing personal injury.
Never use the tool if it is leaking air, the contact safety mechanism is not working, tool
has missing or damaged parts, or requires repair. Make sure all screws and caps are
securely tightened.
Inspect the tool before each use to insure that the trigger, safety mechanism, and spring
are operating properly. Lock the tool in a clean, dry storage area between uses.
Only use parts, nails/staples, and accessories supplied or recommended by FPC
Corporation. Unauthorized parts or fasteners can lead to malfunction and serious injury.
Only personnel trained by FPC Corporation or the distributor shall repair the tool. Do not
modify this tool in any way.
Never use in presence of flammable liquids or gases. The tool produces sparks during
operation.
Never use this tool in sites containing lacquer, paint, benzine, thinner, gasoline, gases,
adhesive agents, and other materials which are combustible or explosive.
Check for live wires. Avoid the risk of electrical shock by checking for live wires that may
be hidden by walls, floors, or ceilings. Turn off the breaker switch pertaining to that work
area.
Do not store this tool in a cold weather environment. Store the tool in a warm area until
the start of work. If it is in a cold area, bring it in a warm area and allow it to warm up
before use.
Manufacturer assumes no responsibility for consequential or indirect damages from the
use of this product.
Save this manual and have it available for tool operators
reference!
IMPORTANT SAFETY WARNINGS: continued
9
2
7760 3 in 1 Nailer