Installation Instructions

MATERIAL SAFETY DATA SHEET
Page 2 of 6
Hazard Statement(s):
Precautionary Statement(s):
H320: Causes eye irritation
H303: May be harmful if swallowed
H313: May be harmful in contact with skin
P264: Wash hands thoroughly after handling
P270: Do not eat, drink or smoke when using this
product
P280: Wear protective gloves/protective clothing/eye
protection/face protection
EU HAZARD CLASSIFICATION PER DIRECTIVE 1999/45/EC:
[Xi] Irritant
Risk Phrases:
R22: Harmful if swallowed
R36/38: Irritating to eyes and skin
Safety Phrases:
S24/25: Avoid contact with skin and eyes
S46: if swallowed, seek medical advice immediately
and show container or label.
HEALTH HAZARDS OR RISKS FROM EXPOSURE:
ACUTE: Contact with molten material will cause thermal burns. This product is not expected to cause adverse health
effects when used as intended. Prolonged or extended contact with product may cause skin irritation. Direct contact
with eyes may cause irritation. Ingestion of this product is not a likely route of entry. May cause gastrointestinal
irritation if swallowed. Not expected to cause respiratory irritation.
CHRONIC: None known
TARGET ORGANS:
ACUTE:
Eye, Skin
CHRONIC:
None known
3. COMPOSITION and INFORMATION ON INGREDIENTS
Hazardous Ingredients:
CAS #
EINECS #
ICSC #
WT %
Hazard Symbol;
Risk Phrases
Ethylene Vinyl Copolymer
24937-78-8
Not Listed in
ESIS
Not Listed
55 - 75%
HAZARD CLASSIFICATION: [Xi] Irritant
RISK PHRASES: R36/38
Resin
69430-35-9
Not Listed in
ESIS
Not Listed
0 – 45%
HAZARD CLASSIFICATION: [Xi] Irritant
RISK PHRASES: R36/38
Resin acids and Rosin acids,
esters with pentaerythritol
8050-26-8
232-479-9
Not Listed
0 – 45%
HAZARD CLASSIFICATION: [Xi] Irritant
RISK PHRASES: R36/38
Hydrocarbon resin
68441-37-2
Not Listed in
ESIS
Not Listed
0 – 45%
HAZARD CLASSIFICATION: [Xi] Irritant
RISK PHRASES: R36/38
Polyethylene Wax
9002-88-4
Not Listed in
ESIS
Not Listed
0 – 10%
HAZARD CLASSIFICATION: [Xi] Irritant
RISK PHRASES: R36/38
Balance of other components. Each of the other components is present in less than 1 percent concentration (0.1% concentration for
potential carcinogens, reproductive toxins, respiratory tract sensitizers, and mutagens)
NOTE: ALL WHMIS required information is included in appropriate sections based on the ANSI Z400.1-2010 format. This
product has been classified in accordance with the hazard criteria of the CPR and the MSDS contains all the
information required by the CPR, EU Directives and the Japanese Industrial Standard JIS Z 7250: 2000. This material is
classified as non-hazardous under OSHA regulations 29 CFR 1910.1200.
4. FIRST-AID MEASURES
Contaminated individuals of chemical exposure must be taken for medical attention if any adverse effect occurs.
Rescuers should be taken for medical attention, if necessary. Take copy of label and MSDS to health professional with
contaminated individual.
SKIN CONTACT: Exposure to non-molten product is not expected to cause adverse effects. Wash hands after handling. If
hot molten product contacts skin, cool under running water. Do not remove solidified product. The contaminated individual
should seek medical attention.
EYE CONTACT: Exposure to non-molten product is not expected to cause adverse effects. If hot product enters the eyes,
flush with water for at least 15 minutes. Contaminated individual should seek medical attention immediately.
INHALATION: If breathing becomes difficult remove contaminated individual to fresh air. Seek medical attention if breathing
difficulties continues.