SDS
SAFETY DATA SHEET
Page 4 of 6
RESPIRATORY PROTECTION: Not required for product as supplied. When thermal processing fumes are generated and
ventilation is not sufficient to effectively remove them appropriate approved respiratory protection must be provided. Heated
product will emit vapors and exposed workers may need to use a NIOSH approved, organic vapor canister type respirator. If
necessary, use only respiratory protection authorized in the U.S. Federal OSHA Respiratory Protection Standard (29 CFR
1910.134), equivalent U.S. State standards, Canadian CSA Standard Z94.4-93, the European Standard EN149, or EU
member states. Oxygen levels below 19.5% are considered IDLH by OSHA. In such atmospheres, use of a full-facepiece
pressure/demand SCBA or a full facepiece, supplied air respirator with auxiliary self-contained air supply is required under
U.S. Federal OSHA’s Respiratory Protection Standard (1910.134-1998) or the regulations of various U.S. States, Canada, EU
Member States, or those of Japan. Air-purifying respirators with dust/mist/fume filters are recommended if operations may
produce mists or sprays from this product.
EYE PROTECTION: Not required for product as supplied. Wear chemical goggles, face shield if handling molten material.
If necessary, refer to U.S. OSHA 29 CFR 1910.133, Canadian Standards, and the European Standard EN166, Australian
Standards, or relevant Japanese Standards.
HAND PROTECTION: Not required for product as supplied. Wear thermal insulating gloves to protect from thermal burns.
If necessary, refer to U.S. OSHA 29 CFR 1910.138, the European Standard DIN EN 374, the appropriate Standards of
Canada, Australian Standards, or relevant Japanese Standards.
BODY PROTECTION: Not required for product as supplied. When thermal processing wear work clothing sufficient to
prevent skin contact. If necessary, refer to appropriate Standards of Canada, or appropriate Standards of the EU, Australian
Standards, or relevant Japanese Standards.
9. PHYSICAL and CHEMICAL PROPERTIES
SOFTENING POINT: 190°F (88°C) EVAPORATION RATE (n-BuAc=1): Not Applicable
SPECIFIC GRAVITY @ 20C: 0.918 – 0.960 (water=1) SOLUBILITY IN WATER: Non soluble
VAPOR PRESSURE, mm Hg @ 20°C (68F): NA pH: NA
ODOR THRESHOLD: No odor
APPEARANCE, ODOR and COLOR: This product is a solid in various colors, with no odor.
10. STABILITY and REACTIVITY
STABILITY: Stable.
DECOMPOSITION PRODUCTS: Thermal degradation produces carbon monoxide, carbon dioxide and/or low molecular
weight hydrocarbons.
MATERIALS WITH WHICH SUBSTANCE IS INCOMPATIBLE: The product may react to strong acids, bases and oxidizing
agents.
POSSIBILITY OF HAZARDOUS REACTIONS: Will not occur.
CONDITIONS TO AVOID: Avoid excessive overheating. Do not add water or other volatile material to molten adhesive.
11. TOXICOLOGICAL INFORMATION
TOXICITY DATA:
No LD50 Data Available for this product
SUSPECTED CANCER AGENT: The components of this product are not listed by agencies tracking the carcinogenic
potential of chemical compounds as follows:
Carcinogenity
NTP Regulated
No
IARC Regulated
No
OSHA Regulated
No
IRITANCY OF PRODUCT: This product can cause skin and eye irritation.
SENSITIZATION TO THE PRODUCT: These products are not known to cause human skin or respiratory sensitization.
REPRODUCTIVE TOXICITY INFORMATION: Listed below is information concerning the effects of this product and its
components on the human reproductive system.
Mutagenicity: The components of this product are not reported to produce mutagenic effects in humans.
Embryotoxicity: The components of this product are not reported to produce embryotoxic effects in humans.
Teratogenicity: The components of this product are not reported to produce teratogenicity effects in humans.