SDS

SAFETY DATA SHEET
Page 2 of 6
GHS Hazard Classification(s):
None known
Hazard Statement(s):
Precautionary Statement(s):
None known
None known
HEALTH HAZARDS OR RISKS FROM EXPOSURE:
ACUTE: This product as supplied is not expected to cause adverse health effects when used as intended. Ingestion of
this product is not a likely route of entry. May cause gastrointestinal irritation if swallowed. Not expected to cause
respiratory irritation.
CHRONIC: None known
TARGET ORGANS:
ACUTE:
None known
CHRONIC:
None known
3. COMPOSITION and INFORMATION ON INGREDIENTS
Hazardous Ingredients:
CAS #
EINECS #
ICSC #
WT %
GHS CLASSIFICATION(S)
Ethylene Vinyl Copolymer
24937-78-8
Not Listed in
ESIS
Not Listed
55 - 75%
Not Classified
Resin
69430-35-9
Not Listed in
ESIS
Not Listed
0 – 45%
Not Classified
Resin acids and Rosin acids,
esters with pentaerythritol
8050-26-8
232-479-9
Not Listed
0 – 45%
Not Classified
Hydrocarbon resin
68441-37-2
Not Listed in
ESIS
Not Listed
0 – 45%
Not Classified
Polyethylene Wax
9002-88-4
Not Listed in
ESIS
Not Listed
0 – 10%
Not Classified
Balance of other components. Each of the other components is present in less than 1 percent concentration (0.1% concentration for
potential carcinogens, reproductive toxins, respiratory tract sensitizers, and mutagens)
NOTE:This product has been classified in accordance with the hazard criteria of the CPR and the SDS contains all the
information required by the CPR, EU Directives and the Japanese Industrial Standard JIS Z 7250: 2000. This material is
classified as non-hazardous under OSHA regulations 29 CFR 1910.1200.
4. FIRST-AID MEASURES
Contaminated individuals of chemical exposure must be taken for medical attention if any adverse effect occurs.
Rescuers should be taken for medical attention, if necessary. Take copy of label and MSDS to health professional with
contaminated individual.
SKIN CONTACT: Exposure to non-molten product is not expected to cause adverse effects. Wash hands after handling. If
hot molten product contacts skin, cool under running water. Do not remove solidified product. The contaminated individual
should seek medical attention.
EYE CONTACT: Exposure to non-molten product is not expected to cause adverse effects. If hot product enters the eyes,
flush with water for at least 15 minutes. Contaminated individual should seek medical attention immediately.
INHALATION: If breathing becomes difficult remove contaminated individual to fresh air. Seek medical attention if breathing
difficulties continues.
INGESTION: Routine use of this product is not expected to cause any situation which could lead to ingestion. If this
product is swallowed, CALL PHYSICIAN OR POISON CONTROL CENTER FOR MOST CURRENT INFORMATION.
If professional advice is not available, do not induce vomiting. Never induce vomiting or give diluents (milk or water) to
someone who is unconscious, having convulsions, or unable to swallow.
MEDICAL CONDITIONS AGGRAVATED BY EXPOSURE: None known.
RECOMMENDATIONS TO PHYSICIANS: Treat symptoms and eliminate overexposure.