Instruction Manual

DISNHUMD/CQL1893-B Humidifier LED Bluetooth Speaker
Instruction Manual (Read before proceeding)
Power:
 Humidifier:
Plug the small connector of the included USB power cable into the USB power port on the back of unit
Plug the large connector into a USB power port or into a compatible 5V USB adaptor (not included) and
plug into a wall socket.
The LED indicator will turn red when the speaker is connected to a power source.
 Bluetooth Speaker:
The speaker is powered by USB or built-in battery.
To charge the battery
Insert the small connector of the supplied micro-USB power cable into the USB power port on the back of
the speaker.
Insert the large connector into the USB port on a computer or a 5V USB adapter (not included) and plug
into a wall socket
The LED indicator will turn red when the speaker is connected to a power source.
Diagram:
1. Humidifier button
2. LED Power Indicator
3. Micro USB power port
4. Bluetooth Power Switch
Set Up the Humidifier
 Remove the cover from the unit
 Take of humidifier stick apart then put the spring into the bottom of stick.
 Wet the entire sponge wick and then place it inside
 Snap the humidifier stick back to the top.
*Note: Use only clean water. Do not use essential oils, as they can block humidification or damage the humidifier
Do not lose the spring