User's Manual

P.1
Manual of Wireless Transmitter
AM6003
Replacing battery:
 Please open the cabinet at the location of arrow with
screwdriver. Then, follow the diagram to insert the
A23 alkaline battery with positive side on the top.
Code Setting
 The code is set by manufacture, and there are combinations
of codes up to 256. In order to avoid the interference, you
can set the code by adding or removing jumpers of the
alarm. Please make sure that the code setting of the
transmitter must match with that of the receiver.
Eg. If the code of the receiver is 6,7,8; the code of the
transmitter must also be 6,7,8. If the interference continues,
please re-set the code and do the same procedure for both
transmitter and receiver.
Mounting on the window
 Please remove the back of the case by pushing in the tab on
the bottom by screwdrivers. Mount the back of the case on the
wall and snap the front case back on. In case of using double
side tapes, please ensure the wall is dry and clean.
Alighting the position for alarm and magnet
 Ensure that the arrow sign on the alarm must be opposite to
the arrow on the magnet.