MSDS

---------------------------------------------------------------------------

COMPLEMENTARY COATINGS CORP

MATERIAL SAFETY DATA SHEET

SU0001092-01

---------------------------------------------------------------------------

SECTION 4 - FIRST AID MEASURES

---------------------------------------------------------------------------

EMERGENCY FIRST AID:

EYE CONTACT: Flush at once with large amounts of lukewarm water for at

least 15 minutes and get medical attention.

SKIN CONTACT: Remove from skin with soap and water. Remove drenched

clothing. If irritation persists, consult a physician.

INHALATION: If affected by inhalation of vapor or spray mist, remove to

fresh air. If necessary, restore breathing; in this case

contact physician at once.

INGESTION: If victim is conscious, give 2 glasses of water to dilute.

Do not induce vomiting. Consult physician or poison control

center at once.

NOTE TO PHYSICIAN:

Not Applicable.

---------------------------------------------------------------------------

SECTION 5 - FIRE FIGHTING MEASURES

---------------------------------------------------------------------------

FIRE AND EXPLOSIVE PROPERTIES OF THE CHEMICAL:

Flammability Classification . . . . . : N/A

Flashpoint . . . . . . . . . . . . . : N/A

Explosion Level . . . . . . . . . . . : Low - 1.1

High - 8.4

EXTINGUISHING MEDIA

Use extinguishing media appropriate for surrounding fire. After

water evaporates, remaining material will burn; use CO2, dry chemical

or foam (National Fire Protection Association Class B extinguisher).

FIRE-FIGHTING PROCEDURES AND EQUIPMENT

Full protective equipment including self-contained breathing

apparatus should be used. Water spray may be ineffective. If water

is used, fog nozzles are preferable.

UNUSUAL FIRE AND EXPLOSION HAZARDS

Closed containers may explode when exposed to extreme heat; use

water spray to cool. Product in open containers may spatter when the

temperature exceeds boiling point of water.

---------------------------------------------------------------------------

SECTION 6 - ACCIDENTAL RELEASE MEASURES

---------------------------------------------------------------------------

STEPS TO BE TAKEN IN CASE MATERIAL IS RELEASED OR SPILLED

Ventilate as described in Section 8. Avoid unnecessary skin

contact. Stop and/or contain spill if it can be done safely.

Avoid discharge into drains, sewers or waterways.