Specification

6-VOLT XRC SERIES
TECHNICAL DATA
Heads
All metal formed aluminum lampheads. The die
cast metal three dimensional swivel assembly
permits approximate aiming adjustment from
80° vertical and 358° rotation. The placement
is secured with a lockable pivot mounted on a
rotating base ring.
Lamps
Designed specifically for emergency lighting
applications, the PAR 36 sealed beam type
design insures optimum glare-free light
distribution along with horizontal and vertical
adjustment by rotating the lens within the
housing. Tungsten halogen lamps maximize
light output with lower wattage.
Housing
The rugged 22-gauge die-formed cold rolled
steel housing is finished with white corrosion-
resistant polyester powder coat paint. Cabinet
has keyhole mounting slots and knockouts in
rear and side for AC/DC wiring connections and
has universal mounting pattern.
Line-Latched
Sure-Lites’ line-latched electronic circuitry
makes installation easy and economical. A labor
efficient AC-activated load switch prevents
the lamps from turning on during installation
to a non-energized AC circuit. Line-latching
eliminates the need for a contractor’s return
to a job site to connect the batteries when the
building’s main power is permanently turned
on.
Solid-State Charger
Supplied with a 120/277 VAC, voltage
regulated solid-state charger. Immediately
upon restoration of AC current after a power
failure, the charger provides a high charge
rate. The charge circuit reacts to the condition
of the battery and alters the rate of charge in
order to maintain peak battery capacity and
maximize battery life. Solid-state construction
recharges the battery following a power failure
in accordance with UL 924.
Overload and short Circuit Protection
The solid-state overload monitoring device in
the DC circuit disconnects the lamp load from
the battery should excessive wattage demands
be made and automatically resets when the
overload or short circuit is removed. This
overload current protective feature eliminates
the need for fuses or circuit breakers for the DC
load.
Brownout Circuit
The brownout circuit in Sure- Lites’ units
monitors the flow of AC current to the unit and
activates the emergency lighting system when
a predetermined reduction of AC power occurs.
This dip in voltage will cause most ballasted
fixtures to extinguish causing loss of normal
lighting even though a total power failure has
not occurred.
Solid-State Transfer
The unit incorporates a solidstate switching
transistor which eliminates corroded and pitted
contacts or mechanical failures associated with
relays. The switching circuit is designed to
detect a loss of AC voltage and automatically
energizes the lamps. Upon restoration of the
AC power, the emergency lamps will switch off
and the charger will automatically recharge the
battery.
Low-Voltage Disconnect
When the battery’s terminal voltage falls below
80% of the rated voltage, the low-voltage
circuitry disconnects the lighting load. The
disconnect remains in effect until normal utility
power is restored, preventing deep battery
discharge.
Test Switch/Power Indicator Light
Conveniently located combination Test Switch/
Power Indicator Light allows for manual
verification of proper operation of the transfer
circuit and emergency lamps.
Sealed Lead Calcium Battery
The fully sealed, long-life, maintenance-free
lead calcium battery is ideal for emergency
lighting applications. These recombinant cycle
batteries typically provide eight to ten years of
life and may be operated in any position.
Sealed Nickel Cadmium Battery
Sure-Lites sealed nickel cadmium batteries
are maintenance free and utilize positive
and negative sintered plate construction
with polypropylene separators offering high
discharge capability and stable performance
over a wide range of temperatures. The
specially designed resealable vent automatically
controls cell pressure, assuring safety and
reliability. The commercial grade nickel
cadmium battery can be operated in ambient
temperatures of 0° to 50°C and still provide a
minimum of 1 1/2 hours of illumination.
Warranty
This Sure-Lites' product is backed by a firm five
year warranty against defect in material and
workmanship (excluding lamps). Maintenance-
free, long-life, sealed nickel cadmium batteries
carry a 15-year pro-rata warranty. Maintenance-
free, long-life, sealed lead calcium batteries
carry a 5-year pro-rata warranty.
PHOTOMETRICS
Eaton
1000 Eaton Boulevard
Cleveland, OH 44122
United States
Eaton.com
Specifications and
dimensions subject to
change without notice.
Eaton’s Cooper Lighting Business
1121 Highway 74 South
Peachtree City, GA 30269
P: 770-486-4800
www.cooperlighting.com