User Manual

7
PROPRIETARY
Connecting to the Mote
The WMR is used to connect the Mote to the Acheron software, the settings below are for initial setup
of wireless and coaxial devices. Once these settings are in effect, it is not necessary to go into the menu
to change them as long as the same type of device is being connected to the WMR.
Wireless Devices
*Once the settings in steps 1 and 2 are set and confirmed correct for the type of device connected to
the WMR, one may simply connect to the device starting at step 3.
Once the WMR is connected to the software and streaming:
1. Go to Menu – Edit Device Settings
2. In device settings, ensure PA/LNA bypass and enable DC Power are unchecked.
3. If they are checked, uncheck them. If not, exit and proceed to next step.