User Manual

8
PROPRIETARY
Connecting Devices
The WMR is used to connect Wireless or Coax devices to the Acheron software, the settings below are
for initial setup of wireless and coaxial devices. Once these settings are in effect, it is not necessary to go
into the menu to change them as long as the same type of device is being connected to the WMR.
Wireless Devices
*Once the settings in steps 1 and 2 are set and confirmed correct for the type of device connected to
the WMR, one may simply connect to the device starting at step 3.
Once the WMR is connected to the software and streaming:
1. Go to Menu – Edit Device Settings
2. In device settings, ensure PA/LNA bypass and enable DC Power are unchecked.
3. If they are checked, uncheck them. If not, exit and proceed to next step.