Installation Guide
Table Of Contents
5
Introduction
Accessory
You can use the Input Module with the enclosure (ENCR-10). The enclosure is sold separately, and you can install two
Input Modules in one enclosure. The enclosure includes a power status LED board, power distribution board, power
supply, and tamper. To learn how to install the Input Module in the enclosure, refer to
Using the Input Module with the
enclosure.
•
There is no optimal height for installing ENCR-10 on the wall. Install it to a safe and convenient location for you
to use.
•
Fixing screws for the enclosure, the device, and the power supply cable are included in the ENCR-10 package.
Use each screw correctly by following the details below.
- Fixing screws for the enclosure (diameter: 4 mm, length: 25 mm) x 4
- Fixing screws for the device (diameter: 3 mm, length: 5 mm) x 6
- Fixing screws for the power supply cable (diameter: 3 mm, length: 8 mm) x 1
ENCR-10