User Guide

Auth
15
• Job Code: Select whether or not to use Job Code.
4 To save settings, press OK.
NOTE
• When Enabled is set for Job Code, you can change the user job code. You can select the desired job code by pressing OK long and
authenticating.
Fingerprint
You can change settings regarding the fingerprint authentication.
1 Press ESC and authenticate with the Admin level credential.
2 Select AUTH > Fingerprint, then press .
3 Select the desired item and then change the settings by pressing or .
• Security Level: Set the security level for 1:N authentication.
• Matching Timeout: Set the fingerprint matching timeout. If the authentication is not completed during a set time, the authentication will
fail.
• View Image: Set to view the original image when scanning the fingerprint.
• Sensor Sensitivity: Set the sensitivity of the fingerprint authentication sensor. To obtain more precise fingerprint information by
increasing the sensor sensitivity, set the sensor sensitivity higher.
• 1:N Fast Mode: Set the fingerprint authentication speed. If you select Auto, the authentication speed will be set according to all
fingerprint templates enrolled on the device.
• Template Format: Set the fingerprint template format. SUPREMA is set as the default, and if you change the template format, all
fingerprints saved previously cannot be used. Use caution when changing the Template Format.
• Sensor Mode: When Auto On is set, the fingerprint sensor recognizes a user's fingerprint and turns on. When Always On is set, the
sensor is always on.
• Advanced Enrollment: Inspect the quality of a scanned fingerprint in order to save high quality fingerprint information When Use is set
and the quality of the fingerprint is low, it notifies such information to the user and helps the user scan the fingerprint correctly.
• Duplicate Check: When registering fingerprints, you can check duplicates.
4 To save settings, press OK.
NOTE
• Change the template format after deleting the fingerprint information of all users. If the fingerprint information of a user has been
enrolled, the template format cannot be changed.