Manual

Water and Electrical Requirements
Electrical
220V, 60Hz 10Amp fuse or circuit breaker
We recommend an individual branch circuit meant only for the Washer Dryer.
The Washer Dryer is equipped with a power cord and a four prong NEMA 14-30P plug.
Never use an Extension cord
Electrical ground is required on this appliance. This unit is equipped with a four prong grounding plug for
use in a properly installed and grounded outlet.
Warning
Improper connectionof the equipment grounding conductorcan result in a risk of electric shock. Check
with a qualified electrician or servicer if you are in doubt on grounding the appliance. Do not modify the
plug provided with this appliance. Have a qualified electrician install the plug into the wall receptacle if the
plug does not fit the outlet. To prevent risk or fire, electric shock or personal injury all wiring and ground-
ing must be done in accordance with National Electrical Code, local codes and ordinances. The owner of
the appliance is responsible to provide adequate electrical service for this appliance.
Water
Water pressure of 30 to 120 p.s.i, is required to correctlyfill the Washer Dryer. Pressure of less than 30
p.s.i, may cause a failure in the water valve or extended fill time. The inlet valve system may not shut off
correctly. To avoid the possibility of water damage should a hose leak, always have faucets accessible.
Turn off faucet when Washer Dryer is not in use.
Drain Facility
We recommend the height of the standpipe to be not higher than 2.63ft and not lower than 1,64 ft.
Make sure the drain facility is capable of accepting the drain hose pipe in a secure manner.
Flooring
For best performance the unit must be installed on a solidly constructed floor. Wooden floors need
reinforcement to minimize machine vibration. Carpeting and soft tile surfaces are contributing factors in
vibration and may cause the Washer Dryer to move slightly during the spin and dry cycles. Never install
the Washer Dryer on a raised platform or on any weak structure. Proper flooring is the responsibility of
the owner.
Location
We recommend the Washer Dryer not to be installed in areas where water may freeze or boil. The
Washer Dryer maintains some amount of water in its internal components like the valve, pump and in the
hose areas. This can lead to damage to belts, pump, motor, hoses and other components. Make sure the
operating temperature is not above 60 degrees R Your Washer Dryer is a ventless system, therefore it
can be installed in a closet or an in an alcove.
Warning
Your Supra washer Dryer is manufactured for operation on 60Hz AC approved electrical service. This
model is not designed for use on 50 Hz AC electrical service. We do not recommend conversion.
For Technical Assistance or if your Washer Dryer requires service, replacement parts or
accessories contact Supra Appliances Technical Service toll free 1,877,44,SUPRA
Page 8