Manual

Installation sheet
Tools needed for Installation
• Multi wrench
---_ _-Utility Knife
• Channel Lock
• Nut driver
• Level
• Screw driver - Flat Blade
Electrical
Refer to serial plate for specific
electrical requirements
Water
Washer Dryer needs one standard
3/4 inch water supply faucet with
a pressure between 30 to 120
pounds per square inch
Parts supplied for installation.
Inlet Water Hose - One
Washers - Two
Cabinet Dimensions
VENTED WASHER DRYER-
VENT PIPE CONNECTION
- This washer dryer expels damp air during the (ff'!w!period.
This damp air must be exhausted outside of the room where
unit is installed.
- To properly exhaust the air screw pipe A into base B in such
a manner that the tube is pointed upward.
- The exhaust pipe A can not be longer than 2 meters in order
to avoid reduction in dryer performance.
- The pipe A has to be correctly fitted to the base B in order
to avoid leakage during the washing or drying process.
Side View
Rear View
A
A
C
@
Width 23.62 inch
U
c
Y=
C71
-r
Page 4