User's Manual

5
Simeon 5T and 6T Pendant Transmier
The Simeon 5T Transmier has 96 channels available over an UHF frequency
band to allow for the best possible sound quality and performance. The Simeon
6T Transmier oers 16 high denion digital audio channels, each with two
posions (A & B) that allow for easy setup of two transmiers side by side, and
can be used in any country. Your transmier can be interfaced with a boom
(headset) mic, as well as other audio inputs. They can either be used hand-held,
or worn around the neck or at the waist in conjuncon with a boom (headset)
mic. It is recommended that you charge the transmier fully before its inial use.
It is possible to adjust you transmier microphone sensivity to accommodate
non-standard microphones and other special requirements. If you need to
change the microphone sensivity please contact your point of sale for advice.
The Simoen 5T and 6T come with high capacity rechargeable baeries
preinstalled. They should be charged with the Simeon 602 Charging Cradle.
Simeon 5M and 6M Hand-held Transmier/Microphone
The Simeon 5M and 6M are hand held pass-around microphones.
Open the transmier baery compartment [42] and insert two NiMH
baeries (supplied), taking care to observe the correct baery polarity. Never
use disposable (alkaline) baeries in combinaon with the charging system.
It is recommended that you charge the transmier fully before its inial use.
The Simeon 5M and 610TM should be charged with the Simeon 602. Inside
the Simeon 6M baery compartment there is a Main (M) and Secondary (S)
mode switch. In normal operaon, this switch should be in the M posion. For
addional control over the hand-held microphone from the pendant transmier,
the switch can be put in the S posion. It is possible to adjust you transmier
microphone sensivity to accommodate non-standard microphones and other
special requirements. If you need to change the microphone sensivity please
contact your point of sale for advice.
Simeon 602 Transmier Charging Cradle
The Simoen 602 Transmier Charging Cradle allows for the easy simultaneous
charging of any two Simeon 5T, 6T, 5M, or 6M Transmiers, in any combinaon.
Idenfy the correct power cable for the charging cradle. Plug in the cradle [44].
Place the transmiers into the Charging Pockets [45]. When inserng the 5T and
6T transmiers, make sure the front of the receiver is facing towards the centre
of the charging cradle. The Simeon 5T, 6T, 5M and 6M will turn o automacally
when they are placed in the charging cradle. A steady red ‘ON’ charging indicator
will light during charging; a steady green indicator will light once charging is
complete [46]. Internal charging circuitry will sense when charging is complete
and will terminate charging automacally. Flashing red indicates a failure to
charge. check and replace baeries as necessary.