User's Manual
3
Setup
Carefully unpack the soundeld system and separate its components.
Simeon Audita Portable Soundeld Receiver
Your Simeon Audita System includes either a dual-digital and a dual-FM
receiver module, to be used with the corresponding Simeon transmiers. It also
includes an integrated speaker, and mulple inputs and outputs. It is at the core
of the enre sound system.
It is recommended that you charge the receiver fully before its inial use.
Idenfy the correct power adapter for the receiver. Cauon: never use non-
standard power adapters to charge your system. Plug in the receiver to charge
the baery [6]. Make sure the receiver is OFF while it is charging [1]. It takes
about 10 hours for the receiver to charge. The baery status indicator [15]
will scroll through its coloured lights during charging. A connuous green light
indicates when charging is complete.
The transmier and Receiver channels on both the Audita Digital and Audita
FM Systems will have been assigned before shipping. It will only be necessary to
change the channels if the preassigned channels conict with other FM or Digital
systems in your facility.
OPTIONAL Omnipanel 900 Flat Panel Loudspeaker
The oponal Omnipanel 900 gives great acousc performance and outstanding
speech intelligibility in a small, ecient format. The at panel speaker can be
mounted almost anywhere, and be easily connected to the system when you
need the addional performance of an installed system..
The Omnipanel 900 can either be set up on a tripod oor stand or it can be
wall mounted. Simply slot the Speaker Mount [19] onto the top of either the
Floor Stand or the Wall Mount aer they are in place. Tighten the Fastening Knob
[20] to ensure the safety of the Omnipanel. Make sure not to over-fasten the
knob, as this may cause damage to the Floor Stand or the Wall Mount. Use only
the included Speakon cables to connect the Omnipanel to the receiver. Connect
the cable into back of the Omnipanel [17] and rotate it to the right to lock it in
place. Do the same on the side of the receiver [7]. Move the Speaker Switch [8]
to the “External Speaker” seng to transfer sound from the internal speaker to
the Omnipanel. To unplug the cables pull down on the Speakon “Quick Lock,”
rotate the cable to the le and disconnect it. Be sure to move the Speaker Switch
back to the “Internal Speaker” seng when you no longer want to output sound
through the Omnipanel.