User's Manual
2.2.3 Encoding the Receiver
Before using the wireless for the rst time or aer installation before the electricity is
delivered to the unit, the receiver must be matched to the transmitter. To do this, take o
the clear top of the receiver (use proper screwdriver). Aer the top has been taken o set
the code in the DIP switch. (see Illustration 6 Receiver components and illustration 5
Receiver picture) Set your personal code, which must be the same for the transmitter and
for the receiver. e code can only be set when there is no electrical source.
2.2.4 Optical signals in the Receiver
Easily seen on the top of the Receiver (le side) are three LED lights. ese signals show if the
unit is working correctly.
e green LED 1 shows voltage supply is present and the receiver is on.
e red LED 2 shows when a button on transmitter is being pressed. As long as the light is on
when the button is being pressed, the unit is working perfectly.
If the light starts to ash, there is interference in the signal or the signal is weak.
e red LED 3 is on when the receiver is functional. Only when this light is on can the signal be
received and the functions carried out.
2.2.5 Internal Antenna
e receiver utilizes an internal antenna. is antenna cannot be shortened, moved or
otherwise altered. e manufacturer has no liability if the antenna has been altered in
any way.
2.2.6 Functions of the Receiver
e receiver works with 2 relays and a start/stop relay. e relays switch the current to the
proper switch output. Please see the technical data Section 2.2.
e following functions are built into the receiver:
a) Standby Mode
When hooked up to the supply voltage, the receiver is in standby mode and LED lights 1
and 4 are on. LED 2 and 3 are not on. (see Illustration 8) In standby mode no function
can be varied out. e relays are not functional.
b) Operational Mode
In the operational mode the switching relays can be initiated through depressing the
buttons on the transmitter. is mode can be reached only from standby mode. In
operational mode, the LED 1, 3 and 4 are lit.
c) Automatic stop with frequency interference
e receiver can automatically mode to standby mode when another transmitter with the
same frequency is detected.