User's Manual
2.1.5 Changing the battery
To change the battery, open the back of the transmitter by removing the small screws
behind the rubber protective cover. (Illustration 4 opening the back cover) Aer
removing the cover, carefully remove the old battery and replace it only with one as
described by the manufacturer. (see 2.1.2 Technical Data) Before installing the new battery
insure that the connector is free from corrosion. Should this not be the case, any corrosion
can be easily removed by means of a small brush. Aer the new battery has been installed,
replace the cover carefully by means of the four small screws.
Aer changing the battery, please make sure the rubber seal on the transmitter is in
place correctly or the sealing of the unit cannot be guaranteed. Used batteries should
be disposed of according to national regulations.
Illustration 4:
Opening the Transmitter
and changing the battery
2.1.6 Internal Antenna
e transmitter utilizes an internal antenna. is antenna cannot be shortened, moved
or otherwise altered. e manufacturer has no liability if the antenna has been altered in
any way.
2.1.7 Operation of the Transmitter
e transmitter has 2 pressure buttons (green) as well as a stop (red). Each button
corresponds to a switch in the receiver and activates this switch as long as the button is
depressed. e stop button, when depressed, turns o all switches in the receiver. e
stop button always has priority so that it will turn o all switches even if one of the other
buttons is being operated. e stop button automatically puts the unit in standby mode.