User's Manual
2.1.2 Technical Data – Transmitter
Frequency FM 914.5 MHZ
Number of Functions 2 plus emergency stop
Antennae internal (wire antennae 50mm)
LED light for transmission red
LED light battery level red
Battery 9 volt
Dimensions 120mmx65mmx25mm
Weight
Ingress Protection Level IP65
Operational Temperature -20 C to +50 C
2.1.3 Encoding the system
Before using the wireless system for the rst time or aer installation, the transmitter
must be matched to the receiver. To do this open the back of the transmitter by way of
the 4 small screws under the rubber protective cover. (see Illustration 4 Opening the
transmitter). Aer removing the back cover, you can see an 8 position code bank directly
above the battery. (see Illustration 3 A & B). Set your personal code, which must be the
same for the transmitter and for the receiver.
Encoding must occur prior to connecting the receiver to the source of electricity.
2.1.4 Optical signals on the transmitter
e transmitter has 2 LED lights. (Illustration 1) LED 1 lights up when one of the buttons
is depressed. is signal shows the transmitter is sending a signal to the receiver. LED 2
shows the status of the battery. As long as this light does not go on when the transmitter is
being used, the battery has enough energy to work correctly. As soon as this light goes on
during operation, however, the battery must be changed immediately as further operation
of the unit cannot be guaranteed and injury to person or property might result.
Illustration 3A Illustration 3B