User's Manual

SHANGHAI SUPERSUN TECHNOLOGY LIGHTING CO.,LTD
User Manual
WARNING:
CAUTION: Changes or modifications not expressly approved by
the party responsible for compliance could void the user's
authority to operate the equipment.
Please follow the instructions carefully. Failure to follow installation could cause
accident such as falling, the electric shock, a fire etc.
Please do not remodel the lamps and adjust the parts in order to avoid falling,
electric shock, damage and other accidents.This device complies with Industry Canada
licence-exempt RSS standard(s). Operation is subject to the following two
conditions:
This device may not cause interference, and
(2)this device must accept any interference, including interference that may cause
undesired operation of the device.
Le présent appareil est conforme aux CNR d'Industrie Canada applicables aux
appareils radio exempts de licence. L'exploitation est autorisée aux deux conditions
suivantes :
(1) l'appareil ne doit pas produire de brouillage, et
(2) l'utilisateur de l'appareil doit accepter tout brouillage radioélectrique subi,
même si le brouillage est susceptible d'en compromettre le fonctionnement
FCC Radiation Exposure Statement:
1. This Transmitter must not be co-located or operating in conjunction with any other
antenna or transmitter.
2. This equipment complies with RF radiation exposure limits set forth for an
uncontrolled environment.
3.This equipment should be installed and operated with minimum distance 20cm between
the radiator& your body.
IC SAR Waring :
The device has been tested and compliance with SAR limits, users can obtain Canadian
information on RF exposure and compliance
Le présent appareil est conforme
Après examen de ce matériel aux conformité aux limites DAS et/ou aux limites
d’intensité de champ RF, les utilisateurs peuvent sur l’exposition aux
radiofréquences et la conformité and compliance d’acquérir les informations
correspondantes
Notice:
In order to ensure the safety, when the lamps are maintained and examined, please
entrust the professional personnel of electrical appliances to be responsible for
it, otherwise the non-professional personnel is easy to be in dangerous situation
when they install the lamps.
The power should not exceed the specified range (rated voltage 120v, frequency 60Hz).
Make sure the power is cut off and the environment is dry when you install the lamps.
The lamp is not waterproof so that misuse will lead to an electric shock.